A novel optical polarimeter based on the signal width measurement of the waveform

For the optical polarimeter based on the structure of polarizer–Faraday modulator–analyzer, a novel method of optical rotation measurement was proposed by the waveform analysis of optical intensity signals. The calculation method of the optical rotation was provided by measuring the signal width of the waveform. Furthermore, the optical rotations of sugar solutions with different concentrations were measured by this method, and the fitting degree of obtained fitting curve is 0.9996. This showed that this method was effective.     

聚焦部分相干涡旋光束作用于不同折射率瑞利粒子上的辐射力

 使用聚焦部分相干高斯谢尔涡旋光束,对不同折射率的瑞利粒子的辐射力做了分析,着重研究了相关长度和束腰宽度对辐射力和俘获稳定性的影响。结果表明：相关长度和束腰宽度分别存在临界值,相干长度小于等于其临界值或束腰宽度大于等于其临界值时,可利用其俘获相对折射率大于1的微粒;而在相关长度大于其临界值或束腰宽度小于其临界值时,可利用其俘获相对折射率小于1的微粒。对俘获稳定性的分析表明,需选择适当的相关长度和束腰宽度才能稳定俘获瑞利粒子。     

平顶高斯超短脉冲激光的时间部分相干性对相干合成的影响

 利用准单色光干涉理论,计算了2×2平顶高斯超短脉冲激光在远场的干涉图样,分析了激光的时间部分相干性及其存在束间相位差时对相干合成的影响。计算结果表明,当单路激光输出光束线宽小于100 nm时,理想波前的远场光斑图样和峰值光强基本保持不变,当光束线宽大于100 nm时,干涉减弱衍射效应逐渐增强;光束间存在相位差时,时间部分相干性将破坏远场图样随束间相位差的周期性变化,相位差越大干涉越弱;当超过相干长度时,则为非相干合成,但1/6倍相干长度范围内,仍可视为较理想的相干合成,此时焦斑的斯特列尔比大于0.9,对超短脉冲的相干合成影响可忽略。     

测量行波管电子注的法拉第筒的热分析

利用ANSYS软件对测量行波管电子注截面的法拉第筒探头进行了热分析研究.分析了在单脉冲情况下,测量各种直径的不同脉冲功率密度的电子注、不同脉冲宽度对法拉第筒温度的影响,研究了测量不同功率密度的电子注可以使用的脉冲宽度.结果表明,仅法拉第筒上的注斑区域温度迅速上升,温度梯度较大,其它部分温度基本不变,为保证法拉第筒能够持...     

Site-specific ϕ- and ψ-torsion angle determination in a uniformly/extensively 13C- and 15N-labeled peptide

A solid-state rotational-echo double resonance (REDOR) NMR method was introduced to identify the ?- and ψ-torsion angle from a ¹H–¹⁵N or ¹H–¹³C′ spin system of alanine-like residues in a selectively, uniformly, or extensively ¹⁵N-/¹³C-labeled peptide. When a C_α(i) or a ¹⁵N peak is site-specifically obtainable in the NMR spectrum of a uniformly ¹⁵N/¹³C-labeled sample system, the ψ- or ?-torsion angle specified by the conformational structure of peptide geometry involving ¹⁵N(i)–¹H_αi–¹⁵N(i + 1) or ¹³C′(i − 1)–¹H^Ni–¹³C′(i) spin system can be identified based on ¹³C_α- or ¹⁵N-detected ¹H_α–¹⁵N or ¹H_N–¹³C REDOR experiment. This method will conveniently be utilized to identify major secondary motifs, such as α-helix, β-sheet, and β-turn, from a uniformly ¹⁵N-/¹³C-labled peptide sample system. When tested on a ¹³C-/¹⁵N-labeled model system of a three amino acid peptide Gly–[U–¹³C, ¹⁵N]Ala–[U–¹³C, ¹⁵N]Leu, the ψ-angle of alanine obtained experimentally, ψ = −40 ± 30°, agreed reasonably well with the X-ray determined angle, ψ = −39°.     

n,p柱宽度对超结SiGe功率二极管电学特性的影响

结合SiGe材料的优异性能与超结结构在功率器件方面的优势,提出了一种超结SiGe功率二极管.该器件有两个重要特点:一是由轻掺杂的p型柱和n型柱相互交替形成超结结构,取代传统功率二极管的n^-基区;二是阳极p⁺区采用很薄的应变SiGe材料.该二极管可以克服常规Si p⁺n^-n⁺功率二极管存在的一些缺陷,如阻断电压增大的同时,正向导通压降随之增大,反向恢复时间也变长.利用二维器件模拟软件MEDICI仿真 关键词： 超结 锗硅二极管 n p柱宽度 电学特性     

叶片锯齿尾缘对降低空调室外机气动噪声影响的试验研究

依据现有的叶片尾迹宽度计算公式,计算了一空调室外机风机叶片的尾迹宽度,然后,以此尾迹宽度为参考基准,设计了两组不同形状和大小的锯齿形叶片尾缘,制作并试验研究了锯齿形尾缘对风机气动噪声的影响规律。结果表明,锯齿尾缘有明显降噪效果,正弦形锯齿较正三角形更好。锯齿尾缘通过降低宽频噪声降噪,而对离散噪声影响很小。采用与叶片尾迹...     

微槽道内气体流动特性的实验研究

搭建了微槽道的单相实验台,分析了氮气在不同深／宽比、长径比及水力直径的微槽道中流动特性。层流区的摩擦常数与理论预测值吻合较好（除L=20mm工况）,层流到湍流的转捩均有不同程度的提前（转捩Re数在1000左右）;在湍流区,槽道的长径比变小、相对粗糙度的增大（或水力直径的减小）及长度的减小可使流动阻力增大;拟合出了湍流区...     

Evidence for shape coexistence at medium spin in Rb

Four previously known rotational bands in ⁷⁶Rb have been extended to moderate spins using the Gammasphere and Microball γ ray and charged particle detector arrays and the ⁴⁰Ca(⁴⁰Ca, 3pn) reaction at a beam energy of 165 MeV. The properties of two of the negative-parity bands can only readily be interpreted in terms of the highly successful Cranked Nilsson-Strutinsky model calculations if they have the same configuration in terms of the number of g9/2 particles, but they result from different nuclear shapes (one near-oblate and the other near-prolate). These data appear to constitute a unique example of shape coexisting structures at medium spins.